This is a portable power supply for the Raspberry Pi Pico.
which supports the use of a single 18650 lithium battery for power supply, which can free your pico from the shackles of cables and make it more convenient for you to DIY Pico projects.
The remain power of battery can be read from the 4 LED indicators. You can also read battery voltage and current information by connecting the USB-to-TTL cable to the serial port pins of the UPS.
The charging prompt during charging is very intuitive, and when the battery is fully charged, it will stop charging, and the `Standby indicator` on the panel will light up.
All GPIOs is leading out and providing clear silkscreens which are very convenient for Pico experiments.
It is plug-and-play module.
This device is a power supply device, please pay attention to the positive and negative poles of the battery.
Reverse battery connection may damage your UPS device or Pico development board.Please check the circuit carefully before turning on the power switch to avoid equipment damage caused by short circuit.
Plug & Play
Support Raspberry Pi Pico Only
Monitor battery voltage (error ±2%), monitor battery current (error ±10%).
Monitor the charging current.
If it is not in charging mode, the power LED indicator will not be on, wake up for 5 seconds every 2 minutes to reduce light pollution.
In charging mode, it can judge whether it is fully charged, and stop flashing lights when fully charged.
In charging mode, the LED will flash when it is not fully charged.
Evenly allocate the power ratio of each LED to prevent the load from appearing abruptly.
The static power consumption is less than 10mA.
Serial output data.
Only supports 18650 lithium battery
It is normal that the current consumption can still be read when the PICO is not connected and the power switch is turned on. After all, the board also consumes a small amount of electricity, which can be ignored.
1 x UPS for Raspberry Pi Pico
Note:Pico and Battery are not included