LoRa Shield 868Mhz for Arduino

  • 499 kr

LoRa Shield  is a long range transceiver on a Arduino shield form factor and based on Open source library.The Shield allows the user to send data and reach

Produkten är tyvärr slut i lager. :(

Artikelnummer: 791
Dela

LoRa Shield  is a long range transceiver on a Arduino shield form factor and based on Open source library.The Shield allows the user to send data and reach extremely long ranges at low data-rates.It provides ultra-long range spread spectrum communication and high interference immunity whilst minimising current consumption.
LoRa Shield is based on Semtech SX1276/SX1278 chip, it targets professional wireless sensor network applications such as irrigation systems, smart metering, smart cities, smartphone detection, building automation, and so on.
Using Hope RF’s patented LoRaTM modulation technique the  Dragino Shield featuring LoRa® technology can achieve a sensitivity of over -148dBm using a low cost crystal and bill of materials. The high sensitivity combined with the integrated +20 dBm power amplifier yields industry leading link budget making it optimal for any application requiring range or robustness. LoRaTM also provides significant advantages in both blocking and selectivity over conventional modulation techniques, solving the traditional design compromise between range, interference immunity and energy consumption.
These devices also support high performance (G)FSK modes for systems including WMBus, IEEE802.15.4g. The  Dragino Shield featuring LoRa® technology deliver exceptional phase noise, selectivity, receiver linearity and IIP3 for significantly lower current consumption than competing devices.

Features:

  • Compatible with 3.3v or 5v I/O Arduino Board.
  • Frequency Band: 915MHz/868 MHZ/433 MHZ (Pre-configure in a factory)
  • Low power consumption
  • Compatible with Arduino Leonardo, Uno, Mega, DUE
  • External Antenna via I-Pex connector

Summary

  • 168 dB maximum link budget.
  • +20 dBm - 100 mW constant RF output vs.
  • +14 dBm high efficiency PA.
  • Programmable bit rate up to 300 kbps.
  • High sensitivity: down to -148 dBm.
  • Bullet-proof front end: IIP3 = -12.5 dBm.
  • Excellent blocking immunity.
  • Low RX current of 10.3 mA, 200 nA register retention.
  • Fully integrated synthesizer with a resolution of 61 Hz.
  • FSK, GFSK, MSK, GMSK, LoRaTM and OOK modulation.
  • Built-in bit synchronizer for clock recovery.
  • Preamble detection.
  • 127 dB Dynamic Range RSSI.
  • Automatic RF Sense and CAD with ultra-fast AFC.
  • Packet engine up to 256 bytes with CRC.
  • Built-in temperature sensor and low battery indicator.

Documents

Manual

PART LIST

  • 1 x LoRa Shield (support 868M frequency)

  •  1 x 868~915Mhz Antenna

LEARN AND DOCUMENTS

Learn

 

[Others] LoRa and LoRaWAN for Arduino and Raspberry Pi

Introduce how to use LoRa and LoRaWAN with the Arduino and Raspberry Pi!